How to remove foam double-sided adhesive：

1, can use a high concentration of thinner, that is, banana water cleaning to clear, but the material can not be the surface of paint material, otherwise it may be the color of the paint with the brush off. Use the small shovel used to brush the wall to talk about the layer of foam attached to the surface of the gum without fear of scraping, and then dip the banana water in the gum after brushing the foam and let it corrode for a while. After 1 or 2 minutes, Then use the brush in a circular manner to brush, the glue will slowly fall off. But after the cleaning is more troublesome, and then use clean water to clean up.

2, for the foam glue stuck to the clothes can be cleaned with toothpaste. The foam gum that remains on the door can be hot washed with boiling water.

3, can also use wind oil fine coating after a moment, and then wipe clean, but this will be oily.

4，the adhesive can be softened by a blow dryer, which can weaken its adhesion force and can be easily removed. If there are any small traces, wipe them with a Polish remover.

5，no matter what adhesive tape is attached to it, the main substances attached are chemical organic or polymer substances that can be removed using similar compatibility principles. For example, the adhesive parts of 120 # gasoline wetting foam double-sided adhesive can be used. After a towel wipe, remove, clean; In addition, if there is no gasoline, you can pour a little wine and wipe it with a towel, but the effect is slightly worse than gasoline.

6, if it is foam on the wall double-sided glue. Use eraser along the edge bit by bit to rub in, easy to remove marks. But depending on how sticky you are, it may be different time. If conditional alcohol + eraser works well.

7,the foam on the wall can also take a piece of vinegar cloth to cover the entire area of double-sided adhesive traces. When the adhesive of the double-sided adhesive is completely wet, it can be easily removed with a ruler.

8,A mixture of soap and a little ammonia and turpentine can remove a lot of dirt and make the glass surface more shiny(this section applies to tiles, ceramics, glass, etc.).

The commonly used detergents in the court and salt water, kerosene, toothpaste, etc. have a certain effect on the removal of traces of foam glue. However, the material of the foam glue is different, and the cleaning effect is also different. The traces of the smooth surface are easier to clear. The cleaning agent used in different materials of foam gum is also different. Among them, the washing effect of washing powder and saline on glass is good, and the cleaning effect of kerosene and saline on Blackboard is better.